Note: you might need to remap the midi control in VoiceMeter now that the type is note, instead of the previous "control change"įinally, thank you to Vincent for putting out an amazing sound utility.
Select the Communication->Write Scene Data menu item Open the Korg editor, select the button you wish to illuminate and change the "assign type" to "note", button behavior to toggle, and on value to 1 Turn the Data Encoder to select the Note number which you would like the control to. Route MIDI note on message key number to pfield N as MIDI value 0-127. Preset A5 is a template for transmitting MIDI Note data from Pacer.
Install the Windows driver and the Korg Kontrol Editor. This means that for example this line a1 a2 + a3 will compile as a1 Add a2. Inverted intervals identifying note A-flat This table inverts the above intervals, so that each link in the last column leads to note A-flat. These intervals are shown below on the treble clef followed by the bass clef. Works very nicely and I'm looking forward to putting it to use with the record and play transport controls (if possible).įor those using the nanoKontrol2, if you want to use heavenlot's scripts as is, you'll need to do the following: Middle C (midi note 60) is shown with an orange line under the 2nd note on the piano diagram.
Huge thank you to heavenlot! I used your scripts and was able to setup my Korg nanoKontrol2 to illuminate the button lights when muting. The MIDI/USB 25 NOTE BASS PEDAL ENCODER Unit consists of: An assembled, built and tested Arduino board including a suitable pre-programmed microcontroller, The velocity byte is preset to a value of 100, The MIDI start Note is set to C2 (Note 36), The MIDI channel (1-16) is user selectable via the 4-way DIP switch.